|

Home

|

Contact Us

|

PolarBear

Phone:   1.800.363.7845
Fax:   1.780.349.5904

Bottle Rinsing System
Purpose Rinsing System:
It is intended to provide self-serve customers with a method of keeping their bottles clean and sanitary. It is not designed to wash the bottle in the case of a dirty, contaminated bottle. It is designed to sterilize their nearly clean bottle and eliminate any surface bacteria that may be inside their bottle. By rinsing their bottle every fill or two it greatly reduces the chance of contaminants growing in their bottle. This is a preventative procedure as opposed to a cure to an existing problem. Water supplied is injected with a high concentration of ozone generated inside the bottle washer. Ozone is created using the surrounding oxygen (O2) and is converted to ozone (O3) by electrical current (Cold Plasma Corona Discharge Ozone Generation). Ozone is an effective method of killing bacteria. The contact with the bacteria as well as the residual ozone left in the bottle will help prevent contamination of water bottles.
Electrical Requirements:
The PBD-BRW120 plugs into a standard 110-130 VAC receptacle, which should be dedicated to this application. Total current is about 1 Amp. All wiring and cable/hose routing must be done to local standards, codes, and regulations.
Mechanical Requirements:
1. Drain Line
The drain line should be minimum 5/8” OD and should run in as straight a line as possible and the shortest distance possible. The drain line must also have sufficient slope for drain water to flow out of the PBD-BRW120 via gravity nearly as fast as water flows into the PBD-BRW120 so that water does not back-up in the PBD-BRW120 and overflow.
2. Water source
A water source with a minimum 40 psi and 2.5 gpm is required to feed the PBD-BRW120. This water can be tap water if properly filtered and of sufficient quality or distilled water can be used. This water will be injected with a high content of ozone that will kill bacteria on contact. Distilled water is best however this can become costly and reduce the amount of water available for sale. Titan distiller installs produce a large amount of water at an economical rate that is an ideal source for the PBD-BRW120.
Polar Bear RD System Specs & Prices
Model:
PBD-BRW120
Parts Number:
106002
Machine Weight:
50 Kg (110 lb)
Machine Height:
1118 mm (44”)
Machine Width:
305 mm (12”)
Machine Depth:
305 mm (12”)
Drain-out Pump:
3.3 L/Min; 120 V; 40~60 PSI
Electrical Ratings:
120 Volts
1 Amps
120 Watts
Price List
Bottle Rinsing System #106002-0001, 120V
USD $3,300.00


© 2006 Polar Bear Water Group (1978) Ltd. All rights reserved.